The modern garage door has come a long way from the earlier iterations. In the past, garage doors were controlled by a lever and a counterweight, and a person had to apply a significant amount of force to lift the door open. Today, garage doors are controlled by a remote, and you can get the door opened at the touch of a button. The modern garage door system operates on a hinge and has powerful cables running throughout to balance the weight. However, due to regular wear and tear, the cable might snap off at some point in time. If that happens, you will need to carry out a garage door cable replacement in Marysville, WA. Here is a basic guide to help you with garage door cable replacement.
Removing the Door
Before you snap the cable, you will need to disconnect the garage door from its hinges. If you feel that you are not qualified for the task, you can visit and hire them to replace the garage door cable for you. To pull the cables loose, you must use a vice grip and hold it tight just underneath the rollers at the bottom. Once the cables have come loose, you can then start replacing the older ones.
Installation
Start by installing a new set of cables on the bottom bracket in the beginning. Once that is done, you should pull the cable up to the cable drum on the left side, and then work your way to the right. Garage door cable replacement is a difficult job, and there’s a risk of you getting hurt or cut due to the frayed edges on the cables. If you feel you are not cut out for the job, always hire a professional.
